Hotpoint Fdl 9640

Home › Forums › Public Support Forums › General Enquiries And Questions › Hotpoint Fdl 9640

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • November 21, 2021 at 10:47 pm #100264
    Tjb1976
    Participant

    Hi my washer dryer starts ok runs anti clockwise for about 10 seconds then all the bottom 5 lights flash. Has anyone any ideas

    November 21, 2021 at 11:16 pm #479922
    electrofix
    Moderator

    the fault code is displayed by the lights that dont lfash

    Dave

    November 22, 2021 at 9:15 am #479923
    Tjb1976
    Participant

    Could you elaborate a bit please
    super wash slow spin time save eco wash and play all flash rapid

    November 22, 2021 at 9:28 am #479924
    electrofix
    Moderator

    but what are these lights doing ?

    Dave

    November 22, 2021 at 9:41 am #479925
    Tjb1976
    Participant

    Wash is off. Rinse is off. Spin is on. Dry is on. End is on . Lock is on.
    hope that makes sense tried to upload a pic but it won’t for some reason

    November 22, 2021 at 10:02 am #479926
    electrofix
    Moderator

    i dont know which light is which so going from the bottom tell me which ones are on or off

    Dave

    November 22, 2021 at 10:20 am #479927
    Tjb1976
    Participant

    Thanks for sticking with me
    from the bottom working up I have the first 4 on and the top 2 off
    OFF
    OFF
    On
    On
    On
    On

    November 22, 2021 at 12:27 pm #479928
    electrofix
    Moderator

    looks like fault 15

    which will prob be faulty dryer element

    Dave

    November 22, 2021 at 11:56 pm #479929
    Tjb1976
    Participant

    I had previously tested 42 ohms across the element and at the pcb plug
    tried to earth with the multi meter nothing.
    blew the dust off my old megga to find the element is down to earth.
    tried a cheeky test removed the earth wire to the heater. Selected a drain and spin cycle which it merrily started to run.
    Thank you for your Help
    Your a star
    Regards
    Tim

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.