- This topic has 2 replies, 2 voices, and was last updated 4 years, 3 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
I know someone will know this off the top of there head But what is the ohm`s reading for the tacho.and also what is 2 and 5 flashes mean.
well if it is fault 52 am getting motor over current
i52 code: WP BLDC motor – abnormal high current detected
• Hardware supervising – will be set when abnormal high current of about
1.3 amps are detected.As for tacho all the ones i had faulty were open circuit and machine will run ok it just want heat
Dave
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.