Neff Washer Dyer V6540X1GB/07 error E13

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Neff Washer Dyer V6540X1GB/07 error E13

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 29, 2021 at 10:56 am #100399
    adam67
    Participant

    Hi

    Looking for a bit of help with my washer dryer, it shows error E01 followed immediately by E13, the error codes show up after the drain pump finishes draining.

    I have check out the flood switch, heater elements, water valve, water level switch, pump filter and tried to bypass the door interlock. I also slaved in a used main PCB, the same faults still show.

    I am also curious to know what the small sensor pcb p/n 10008630 does? It is mounted next to the door interlock and has a ribbon cable connection back to the main pcb and a fly lead that goes to a spade connector on a sprung metal plate where the door engages the interlock assy when closed.

    Thanks
    Adam

    December 29, 2021 at 1:15 pm #480455
    electrofix
    Moderator

    interesting, no idea on the pcb. I would look the chip number up to see what it does which may give a clue

    error codes are hard on these machines

    E1 seems to be water control error. if your machine has a float in the base it would seem to point to that

    what i would try is disconnect all wires to the dryer heating element, make them safe and run the machine to see what happens. small amounts of earth leakage on elements often upsets electronics and throws random codes up

    Dave

    January 1, 2022 at 12:38 pm #480456
    adam67
    Participant

    Hi Dave

    Thanks for taking the time to reply.

    The flood switch in the base appears to be operating correctly, as suggested I will try disconnecting the heater elements just in case the insulation is low.

    Happy New Year

    Adam

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.