- This topic has 6 replies, 2 voices, and was last updated 4 years, 1 month ago by
.
-
Posts
-
Good afternoon all,
On a selected cycle the above dishwasher drains, fills, and the drains, followed by F5 displayed, and all led’s flashing.
In the owners manual it states F5 as an insufficient water supply problem, although in this case it is over-filling.
Not sure how to conclusively test the water flow meter, and wonder if I should be looking in other areas?
jontyThanks Dave,
Yes, will do. Reed switch appears to be part of matrix.
Will also have a look at service manual.
Many thanks (again!)jonty
Good morning all,
Checked the wiring to and from flow meter/reed switch to board, and all good.
Diagnostic Mode tried as per manual, which it does start, although aborts cycle as before. i.e. overfills, drains and displays F5
All point to fault in board.
jontyGood morning all,
Checked the wiring to and from flow meter/reed switch to board, and all good.
Diagnostic Mode tried as per manual, which it does start, although aborts cycle as before. i.e. overfills, drains and displays F5
All point to fault in board.
jontyGood evening all,
Well, I’ve got the above dishwasher working, following replacing the main board.
It now appears to function perfectly… however, the display module is “dead!” so appears that this has now also “coincidentally” failed, as I’ve checked, and rechecked the wiring connections between the two boards…
Several things going “pear shaped” recently!!
jonty
- You must be logged in to reply to this topic.