- This topic has 2 replies, 2 voices, and was last updated 3 years, 9 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Hi All,
I have a Beko DW that seems to be going through the program ok but doesn’t heat the water.
I’ve replaced the flow through heater but still the same (the old heater has a resistance of approx 30 ohms, similar to the replacement so I feel the heater is fine.)Is there a thermostat that might have failed or is this pointing to a control board issue? If control board, it’s probably better to scrap the DW as boards are very pricey, right?
The DW doesn’t present any errors on the display. I’m searching for a diagnostic menu, but don’t know if this model has one.
check the wires from the heater to the timer
also check timer board for signs of solder joint problems where the heater connects and the control relay
Dave
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.