- This topic has 6 replies, 3 voices, and was last updated 3 years, 1 month ago by
.
-
Posts
-
Just wanted to check with you guys…
This microwave in question was sparking all over the the place and the inverter blown – burnt smell
Do I need to replace the inverter board and magnetron same time to make good repair?
electrofix wrote: these are panasonic parts so you can usually use the panasonic ones which are far cheaper
Dave
Interesting… do you have the cross reference codes for this and compare against Panasonic? I’ve yet to hear from the owner, I think they were freaked out by the cost of new parts. If I come up with the Panasonic equivalent at much lower prices then they may calm down. Thanks in advance
mag seems to be 2m261-m32 which is on aswo for £42 +vat for gen panasonic
the inverter you need the numbers off it will be something like F606y etc printed on the coil
has inverter burnt out? have you checked. normally blows internal fuse when they do
Dave
electrofix wrote:mag seems to be 2m261-m32 which is on aswo for £42 +vat for gen panasonic
the inverter you need the numbers off it will be something like F606y etc printed on the coil
has inverter burnt out? have you checked. normally blows internal fuse when they do
Dave
Internal fuse is ok which is odd?
Definitely it is the inverter blown as smelt burning and blackening of pcb on the inverter board.
Strange that ASWO usually offer alternative part and I have selected the Panasonic one but not for the inverter. Will look again and thank you for your help.
- You must be logged in to reply to this topic.