- This topic has 2 replies, 2 voices, and was last updated 3 years ago by
.
-
Posts
-
My dishwasher was recently transported as part of a house move. Now it doesn’t work.
It powers up with the Main Switch and immediately begins a wash cycle.
All appears to operate: water enters, water is pumped around, water heats up, water is pumped out, operation pauses and resumes when door is opened and closed. The Cycle can be stopped by using the reset buttons and bleep sounds on termination although the pump does seem to run on a bit.
However, the whole time no lights appear on the facia of the programme buttons at all. Pressing a progamme button has no effect on the wash cycle that I can tell.
I have removed, checked and replaced the Control Module and can see no evidence of damage at all.
My next step will be to get the Control Module tested and repaired by QER.I would be grateful for any other suggestions or ideas for me to try, please.
Thank you.cant think of another problem apart from module fault
have a careful look at solder joints in the module paying attention to any link wire plugs
Dave
- You must be logged in to reply to this topic.