- This topic has 3 replies, 2 voices, and was last updated 2 years, 6 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
It lights up as normal, you can change the settings to any program but it doesn’t start…. press reset and it goes to 001 but still is silent, no clicks from the board, nothing.
When I lifted the polystyrene on the float switch it started to pump out but nothing happens on any cycle to start a program.
I’m assuming it’s the board but any other options are welcome.
Thanks Brett
FD: 9901 000176
Oh I didn’t realise the lock was a magnetic type, where would I offer up a magnet to test it then Dave?
Would I assume in the cabinet end!
https://www.manualslib.com/manual/95…page=11#manual
page 10 / 11
magnet in frame, sensor in the door
Dave
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.