Bosch dishwasher tap light flashing, will not re set

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch dishwasher tap light flashing, will not re set

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • February 8, 2024 at 1:47 pm #102576
    oscar123
    Participant

    Bosch SPV40C10GB/32 tap light flashes and it will not re set even when unplugged.. anyone any ideas? Heat pump element okay but can’t test sensors on it.
    Oscar

    February 8, 2024 at 6:52 pm #489528
    kaibart
    Moderator

    Is there any water I the base? If not the heat pump runs 1st and then drain pump then heat pump again before taking water

    February 12, 2024 at 12:07 pm #489529
    oscar123
    Participant

    No water in the base.. no pump running at all just the “tap” symbol flashing. Disconnected from power supply for 10 minutes as I inspected the base, it will not reset.

    February 12, 2024 at 1:45 pm #489530
    Hollytree_Technical
    Participant

    Have you checked if the valve on the heat exchanger is okay – these are common to go open circuit.

    Jem

    February 12, 2024 at 5:39 pm #489531
    oscar123
    Participant

    I have had that problem in the past many times and carry the valves on the van.. I don’t think I have ever had a fault that would not re set though!
    If anyone has any info on this I would appreciate it model is SPV40C10GB/32 slimline integrated

    February 13, 2024 at 7:56 pm #489532
    neon_3SP_glow
    Participant

    Dont they usually show E19 if the dump valve on heat exchanger fails?

    Are you sure it’s not accidentally in a test mode or something similar?

    Incedentally, had one where the seal on the dump valve failed and it slowly would fill the tub after a program ended, took a while to figure that one out!

    February 14, 2024 at 3:44 pm #489533
    oscar123
    Participant

    No this does not show codes just flashes the tap symbol.. I have had the E19 before and you can aways reset after and get it to run. This dishwasher will not re set at all.. I have ordered a control module as I am sure regardless of the fault you can always re set

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.