- This topic has 4 replies, 3 voices, and was last updated 2 years ago by
.
-
Posts
-
Replaced the sensor and it did not made any difference.
Module on the rear looks clean but then obviously I can’t tell if one relay is faulty. My hunch is the relay switches on the module being faulty as it is not responding to the temperature setting of 160 degs. The display panel is showing the actual temperature until it reached to the set temperature yet still over heating.
owner is keen to have it repaired, and I just wanted to be sure that I am not making a expensive mistake. What have others found?
thanks Matt
when relays go faulty they either dont close or stick closed
use a multimeter on the relays and see if one is short circuit
Dave
if its closed it will be zero ohms
the lowest you would get in circuit would be an element which would be 20 ohms or soif in doubt disconnect one wire off each element
Dave
- You must be logged in to reply to this topic.