- This topic has 2 replies, 2 voices, and was last updated 1 year ago by
.
-
Posts
-
Hi everyone,
been out to this dishwasher (Beko) as the antiflood protection had triggered. There was water in the base which I cleared up and then ran it. After about 10-15 minutes, water started dripping out through the bottom of the fan suction tube. It was quite clogged up, along with the hose that goes from it to the sump. Cleared it all and all seemed ok. After 3 weeks I have had to go back for the same fault, although it is only leaking a very small amount during the cycle.
It is probably a silly question, but what is the fan suction tube for and is there anything else I should be looking for that could cause the issue?Thanks
Mervby the looks of the tube its designed to take condensation and let it flow back into the sump down the tube
check the drain tube its properly clear
Dave
- You must be logged in to reply to this topic.