- This topic has 4 replies, 3 voices, and was last updated 11 months, 1 week ago by
.
-
Posts
-
when switching on the 13amp wall socket to machine there is a click like a relay, , but the electronic program display is dead…I am presuming the programme card is faulty, can anyone please confirm that or any issue it may be.. can’t see any spares listed for the display…Cheers John
cant see any display card listed but that could because have not got serial no
had one the other week where display went on and off, replaced wiring harness and all ok
harness was very cheap and Aswo had stock
Dave
if you let me have the complete serial no will see if i can find a part no for the door harness
you could go back and look at the harness at the bottom of the door first if you want to make sure
Dave
I see on Aswo that there are 3 different door harnesses listed, if this machine has one of the ones where the wires go straight round the hinge in the flexible rubbery tube then these are very common to fail, it is not unusual that when I tug test them to find that half of the wires break, often this will cause intermittent flashing of the display first.
The display module is also a common failure, it is glued into the facia panel and moisture gets past the glue joint and onto the board and kills it (Part No is possibly 1763350007).
My advice would be to check if there is any damage to the wiring at the hinge and if the rubbery tube is damaged it would be worth having a visual on the main circuit board as I have had 2 or 3 where a wire has broken in the door hinge and shorted out on the chassis killing both circuit boards.
If you decide that in this case it is a faulty display then I would suggest that if it has the harness that goes straight round the hinge then you also persuade the customer to change that at the same time as it will almost certaintly soon fail.Jem
- You must be logged in to reply to this topic.