- This topic has 4 replies, 3 voices, and was last updated 6 months, 1 week ago by
.
-
Posts
-
Hi anyone have experience of fitting fridge door seals. I don’t usually do them. This one seems to be moulded on with the inner door. I have the new seal 481946818316 . Do I just cut the old one off with a Stanley it has a lip on it or do I have to screw the liner back . Thanks
cant get a decent picture of the old seal to see fitting
some doors have a plastic channel and the current seal is bunded over the top
does the new seal have a barb moulded at the rear that would lock into a channel
if yes carefully cut the old seal at the bottom somewhere to see if there is a channel underneath before you commit to cutting off the seal completelythere is also a recommendation to warm the seal to remove any kinks
Dave
It has been a long time since I have done one so I may be wrong but if I remember correctly the the channel for the new seal is inside the old one so you have to cut the magnetic bit and both side edges off to reveal it.
Jem
- You must be logged in to reply to this topic.