- This topic has 7 replies, 2 voices, and was last updated 4 months, 1 week ago by
.
-
Posts
-
Good evening,
Have a Zanussi ZDF2020 91151910106 dishwasher which stopped working the other evening while turned on, there are no lights coming on in the control panel now. Checked the power at the plug it’s ok and control board looks ok with no sign of anything blown, no sign of any wires inside the door panel broken or frayed. Need help here on what I could do next?
need to see a good picture of the electronic panel inside
it is probably the board power supply and if i saw what things look like can probably tell you what to test
Dave
electrofix wrote: need to see a good picture of the electronic panel inside
it is probably the board power supply and if i saw what things look like can probably tell you what to test
Dave
This is it here, it won’t let me upload an image due to file size
ok look at the pic
check the resistor (yellow) expecting about 100 ohms
if thats gone you will need a new fusible resistor and the chip (red)
thats most likely whats failed
Dave
electrofix wrote:ok look at the pic
check the resistor (yellow) expecting about 100 ohms
if thats gone you will need a new fusible resistor and the chip (red)
thats most likely whats failed
Dave
Took the PCB out and I’m getting no reading off that resistor in yellow, set multimeter too 200 ohms. If I need them parts, is there a good website to purchase them?
look for resistor type AC03000001000JACCS
3 watts 100 ohm the above number means its a safety fusible type
found on ebay
or
or
as for the chip would need the number off the top of it. often get them off ebay but mouser may have but just beware as am not sure of p&p or any min charges
Daveelectrofix wrote: look for resistor type ac03000001000jaccs
3 watts 100 ohm the above number means its a safety fusible type
found on ebay
or
or
as for the chip would need the number off the top of it. Often get them off ebay but mouser may have but just beware as am not sure of p&p or any min charges
dave1212 lnk 305gn00928c
- You must be logged in to reply to this topic.