F&P Smart Drive 703

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › F&P Smart Drive 703

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 20, 2005 at 9:24 am #10799
    DAM25
    Participant

    Hi hope you can help.
    This is what has happened so far.

    On the last drain and spin cycle the machine would stop draining and would not go to spin cycle.

    Removeded pump found metal clip inside. This caused pump to burn out.

    No water leak or rust stains around motor / pump.

    Replaced pump but now cannot stop the pump from draining.
    Even when machine is plugged in but tuned off still draining

    also please forward diagnostics for the smart drive 703

    daveandjess@hotmail.com

    Any help appreciated, Thanks
    Dave

    July 21, 2005 at 7:35 pm #142780
    KiwiwantsworkinCanada
    Participant

    Re: F&P Smart Drive 703

    Unfortunatly, besides the pump burning out, the pump circut in the control board has also shorted out. The only thing you can do is replace the controller P/N 426895p. Depending on where you live you may be able to buy a reconditioned board from the parts supplier( all F+P boards are recond anyway ) which will be cheaper than the F+P board. 🙁

    July 22, 2005 at 11:58 pm #142781
    DAM25
    Participant

    Re: F&P Smart Drive 703

    Thanks,
    I have found a service guy for F&P.
    Who will sell me a reconditioned part but will also tke my old one for $5
    and let me know what the full problem is.
    Will post results.
    Also
    is possible to get the diagnostics for the 703

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.