Beeping on Fisher and Paykel Smart Drive 608

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Beeping on Fisher and Paykel Smart Drive 608

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 27, 2005 at 11:27 pm #10954
    admin
    Keymaster

    Whilst in filling mode, either initial fill or rinse, the machine will stop and start to beep, until I press the start button again. It will do this more than once in it’s cycle. Can you please help me, I am able to carry out most repairs myself, and being a pensioner the cash is a little hard to come by.

    July 28, 2005 at 7:35 pm #143335
    KiwiwantsworkinCanada
    Participant

    Re: Beeping on Fisher and Paykel Smart Drive 608

    It is probably blocked inlet filters. Remove the cold hose, there should be a filter washer in the tap end of the hose, clean this out and make sure when you put it back in the raised mesh is pointing into the tap. Check filter inside cold valve, get some pliers and pull out the filter, it comes out where the hose screws on.
    If it is making a wooshing noise when filling on cold, and the water is coming in slowly, the cold valve needs replacing. 😉

    November 4, 2005 at 12:13 pm #143336
    sinister_designs
    Participant

    Re: Beeping on Fisher and Paykel Smart Drive 608

    does anyone know the part no for these filling valves as i have the same problem

    Regards
    Jason

    November 5, 2005 at 1:20 am #143337
    Penguin45
    Participant

    Re: Beeping on Fisher and Paykel Smart Drive 608

    Cold water valve – 425320
    Hot water valve – 425324

    HTH,
    Regards,
    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.