HOOVER W/DRY A 8610=001

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › HOOVER W/DRY A 8610=001

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 29, 2005 at 11:27 pm #11006
    DAR01
    Participant

    No heat when drying.

    The resetable t/stat had operated.

    Reset this but still no heat.

    dryer ele test OK, heat sensing t/stat not showing full short circuit.

    I assumed t/stat shot, tried again short circiting leads to t/stat, still no heat.

    Live feed to dryer ele but no neutral, assume problem with control module.
    The neutral goes direct to the control board.

    Anyone any ideas?

    July 30, 2005 at 7:33 am #143580
    Phidom
    Participant

    Re: HOOVER W/DRY A 8610=001

    If the resetable TOC has tripped it’s usually a fan motor problem. Are you sure there is not another thermal fuse you have overlooked?

    July 30, 2005 at 6:15 pm #143581
    eastlmark
    Moderator

    Re: HOOVER W/DRY A 8610=001

    check the wires linking the heater/fan unit to the main loom. Often break there.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.