Diplomat ADP8342 Dishwasher – not turning itself off

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP8342 Dishwasher – not turning itself off

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • August 18, 2005 at 6:32 pm #11407
    joosh
    Participant

    Hi,

    I havean integrated diplomat dishwasher which is less than 12 months old. From about a month after it was installed it has not switched itself off, i have to open the door and put it onto rinse myself otherwise it would be going all day!!

    Has anyone got any ideas,

    Thanks

    Jo

    August 18, 2005 at 7:05 pm #145266
    Penguin45
    Participant

    Re: Diplomat Dishwasher – not turning itself off

    Model number please Joosh – check around edge of door.

    Does it heat the water?

    Penguin45.

    August 18, 2005 at 7:08 pm #145267
    joosh
    Participant

    Re: Diplomat Dishwasher – not turning itself off

    Hi

    Model no is ADP8342

    The water seems to be cold unless it is left on for 2 / 3 hours.
    Although I don’t think it gets hot enough – the dishes do not get very clean.

    Thanks

    Jo

    August 18, 2005 at 7:22 pm #145268
    Penguin45
    Participant

    Re: Diplomat ADP8342 Dishwasher – not turning itself off

    Ok, the programme will be hanging, waiting for the water to reach temperature. Most probably, the safety thermostat will have tripped. This is usually caused by people using 3/4-in-1 tablets. They turn the water to froth and the element overheats.

    As the machine is under guarantee, I’d get the agents out and change back to separate wash agents.

    Regards,
    Penguin45.

    August 18, 2005 at 9:14 pm #145269
    joosh
    Participant

    Re: Diplomat ADP8342 Dishwasher – not turning itself off

    Ok thankyou for the advice – I thought it may be the case of contacting an engineer but didn’t know if I was doing anything wrong.

    Thanks again

    Jo, 😀

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.