Diplomat ADP 8252

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP 8252

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 23, 2005 at 10:30 pm #11529
    Thraxy
    Participant

    Help!,

    I found this forum in a desparate search for answers.

    Basically, the machine wont work. When the on button is pressed nothing happens, no display, nothing at all.

    I have previously replaced the microswitch in the door, so I know its not that (as at least the display lit up then).

    I have tested the “on” switch and made the mistake of opening the thing up (it took me over an hour to put it back together again. I just could not figure out where the spring went).

    After putting the switch back in place, I got my tester out and started prodding. The switch is working fine, and power is going to the PCB module where the display is.

    I think that it is the PCB module (http://www.qer.biz/qer/images/UL1194.jpg) that is at fault, but I am not sure.

    I have found a place to buy the module from for £54 (http://www.qualityelectronicrepairs.co.uk) but will not buy it before I get a second opinion.

    Has anyone else had a similar fault ?
    If the pumps / motors are faulty does the same thing happen?

    Thanks for your anticipated responses. I am on holiday for a week, so I will look back at the forum before I do anything else.

    Regards

    Kev

    August 23, 2005 at 11:09 pm #145674
    Dave_Conway
    Participant

    Re: Diplomat ADP 8252

    If anything else was at fault you would normally expect to see an error code displayed so I think it may well be the PCB to be honest although please re-check the door switch and the on/off switch before condemning it as it’s a costly error if it doesn’t work.

    Power off when checking though 😉 :zap:

    Dave.

    August 24, 2005 at 12:01 am #145675
    Thraxy
    Participant

    Re: Diplomat ADP 8252

    Thanks for the prompt reply Dave.

    I will wait for some more response before taking the plunge, however your answer is very much respected.

    Thanks

    Kev

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.