adp8332

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › adp8332

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 26, 2005 at 5:50 pm #11601
    admin
    Keymaster

    we’ve got the adp9332 dishwasher which is about 1 year old, working fine until an error code f3 came on 4 weeks ago. Found out via this site it maybe the element so took it out and had it tested by a local store, this was proven to be fine. When refitted the element it work fine for afew days then code f3 came back, tried the machine on a cooler wash, wprked fine, then its now tripping the rcd on the mains board!

    Hope yous could shine some light on this matter

    many thanks

    wayne

    August 26, 2005 at 8:53 pm #145958
    Dave_Conway
    Participant

    Re: adp8332

    F3 is a no heat error but it could be casued by a few things, although the rcd tripping would point toward the heater.

    Engineer time to be honest on this one as other components can cause software lock-ups and incorrect error codes being displayed.

    Have a look at Repairs@ for one near you 🙂

    If you do decide to look further, please ensure power is off :zap:

    Dave.

    August 27, 2005 at 3:23 pm #145959
    admin
    Keymaster

    Re: adp8332

    thanks dave, have you had problems with this model in the past, if so what could be the likely problem (themosat, pump, heater or broken wire)
    if this problem cant be sorted by myself, could you advise on whats the going rate for an engineer is please.

    regards

    wayne

    August 27, 2005 at 4:14 pm #145960
    Dave_Conway
    Participant

    Re: adp8332

    Rates vary a lot Wayne, that’s best discussed with the repairer to be honest 😉

    Apart from what I’ve already mentioned, there is little else I can give guidence on to be honest as far as the likely fault goes.

    Dave.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.