- This topic has 8 replies, 4 voices, and was last updated 20 years, 7 months ago by
.
-
Posts
-
came across the above m/c model AWG329, intermitant fault. missing the full programme/advances through to end shuts down. missing rinses and spins.
have tried on final rinses and spins, it’s ok. tried on No 4 prog filled, heated to temp, clicked over off heat, stuck then advanced to end.
anybody has any idea’s I would gratefully apprieciate them.
Ta TELL.
p.s. have checked drain pump,motor, and looked at the p.c.b at the front of washer,nowt visible..Re: whirlpool washer/drier.fast advancing prog-end, info req
This is a Smeg machine, I don’t have access to the tech info here but I’ll check tommorow for you to see if throws any light on it 🙂
Dave.
Re: whirlpool washer/drier.fast advancing prog-end, info req
Does it advance to the end, or to the “spanner”?
Chris.
Re: whirlpool washer/drier.fast advancing prog-end, info req
chris
thanks for your reply, but, come to think of it, i’m sure it’s to the end.
will check??,
whats the prob’s if it’s on the spanner,
Ta TELL.Re: whirlpool washer/drier.fast advancing prog-end, info req
cheers dave, left a little note for chris aswell
TELL.Re: whirlpool washer/drier.fast advancing prog-end, info req
Nothing on Smeg’s disk for this fault I’m afraid TELL, I’ve never seen the fault either 🙁
Sorry.
Dave.
Re: whirlpool washer/drier.fast advancing prog-end, info req
chris
have been told by customer it goes to the end.
TELLRe: whirlpool washer/drier.fast advancing prog-end, info req
Check the 3 solonoids on the cold water inlet, there lies your problem.
- You must be logged in to reply to this topic.