- This topic has 1 reply, 2 voices, and was last updated 20 years, 7 months ago by
.
-
Posts
-
Has anyone had problems with the motor bolts on new(ish) Indesit machines? I have just been to a W161UK. The machine is about 14 months old and all four motor bolts have come loose. The bolts are about 30mm long and have a flat head with no facility to hold it whilst tightening the 10mm nut.
I am going to replace them with the long studs that have been used for years with no problem.
I wonder if there is a kit available as I will have to find the spacers, tubes etc as well.
Bob
Re: Indesit motor mounting bolts
Partfinder shows two different part numbers for the bolts, both of which appear to have a hexagon head, also separate washers and nuts shown. There are also two other parts on the diagram but the numbers allocated to them do not appear in the parts list.
Edit. In fact the bolt that has the smooth head is one of the parts that is in the picture but not in the parts list, perhaps superceded by ‘normal’ bolts. 😥
- You must be logged in to reply to this topic.