GW601 F&P Washer

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › GW601 F&P Washer

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 17, 2005 at 11:23 am #12015
    macs
    Participant

    Hi and thanks in advance for any help recieved. I have the following problem with this machine.
    1) For a week or so the machine has not filled on start, it pulses water valve a couple of times and seems to try and turn agitator and then starts beeping. Sometimes by restarting machine you can get it going and it completes cycle.
    2) Have checked water flow, solenoids, lid switch and OOB switch. All appear to be OK.
    3) Now when plugging in machine the 5 led’s (long wash to short wash inclusive flash, and just keep flashing.
    4) Wash Temp down and then power to enter diagnostic brings up 0000 0010.
    Thanks for any info email: stevemcg@ihug.co.nz 🙂 🙂 🙂

    September 17, 2005 at 5:17 pm #147531
    Penguin45
    Participant

    Re: GW601 F&P Washer

    The display module has failed to detect or monitor the water level switch. Check for poor/broken connections, failing that, the display board must be replaced.

    Power off if investigating inside the machine.

    Regards,
    Penguin45.

    September 18, 2005 at 9:44 am #147532
    macs
    Participant

    Hi Penguin 45
    Thanks for that. Will check out tommorrow am and will post update
    Regards Macs 😀 😀

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.