Instructions needed please

Home › Forums › Public Support Forums › General Enquiries And Questions › Instructions needed please

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 27, 2005 at 9:39 pm #12217
    silverpixie1uk
    Participant

    I know its not while goods but it is electrical 😆 Please can anyone tell me where I can get instructions for a Remington F7027 foot spa. I have surfed the net for hours and I’m a little worried about putting my feet into water with electricity about without knowing what I’m doing.
    Been to the Remington site and they don’t even have any foot spas on there 😯 I really don’t want to end up fried :zap:

    Thanks in anticipation
    Lynn

    September 27, 2005 at 9:50 pm #148433
    kwatt
    Keymaster

    Is it not on a LV adaptor? I always thought those things had to be low-voltage due to the water+electricity=dead-person type rules?

    K.

    September 27, 2005 at 10:45 pm #148434
    silverpixie1uk
    Participant

    Re: Instructions needed please

    Thanks for the reply kwatt I don’t know about low voltage, it has a normal sealed unit 3 pin plug (one put on at manufacture)
    I was given it by a friend who is moving, its hardly been used by the looks of it but the instructions were either thrown out in the move or half way to Belfast.
    If I can find out how it works it will be a great help as I am disabled and find it hard to do my feet.

    Lynn

    September 27, 2005 at 10:55 pm #148435
    kwatt
    Keymaster

    I’ve not taken one apart but I’ve seen a few, a relative used to suffer arthritus (sp?) and that helped her feet. they all seem pretty much internally sealed so that water couldn’t actually get to the electrical components at all.

    I’d check the bucket, make sure there’s no obvious holes or cracks and them run a quick test to ensure no leaks. Beyond that I don’t think I can offer much advice really.

    K.

    September 28, 2005 at 12:42 am #148436
    silverpixie1uk
    Participant

    Re: Instructions needed please

    Thanks again, I did as you advised and apart from the holes for the air to make the bubbles it seemed to be intact so I filled it, waited to see if there were any leaks and then turned it on. All seems well so now I just have to pluck up the courage to put my feet in 😯 😆

    thanks again
    Lynn

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.