How to dismantle a Magimix 5100

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › How to dismantle a Magimix 5100

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 30, 2005 at 8:29 am #12276
    Seamy
    Participant

    I’ve been out with a lady repairing her washing machine she gave me a Magimix 5100 food processor to see if i could repair it, i don’t do a lot of these but it needs a shaft replaced, i’ve removed the base
    & the screws at the top but it won’t come off, is the shaft a left hand screw , i don’t want to force it. Any help would be appreciated.

    September 30, 2005 at 12:16 pm #148823
    kladave
    Participant

    Re: How to dismantle a Magimix 5100

    hi seamy we used to be magimix agents. cut the old plastic shaft off with a junior hacksaw but be carefull not to damage the metal shaft 😆

    September 30, 2005 at 3:25 pm #148824
    Seamy
    Participant

    Re: How to dismantle a Magimix 5100

    Dunno what to make of that, where do i cut it off & where is the metal shaft, how far up does it come up? How is new one then attached?

    October 1, 2005 at 8:24 am #148825
    kladave
    Participant

    Re: How to dismantle a Magimix 5100

    as i said be carefull. if you cut the first 10mm off the top of plastic shaft you will seethe metal shaft inside once off the new plastic shaft is very tight to push on

    October 1, 2005 at 9:36 am #148826
    Seamy
    Participant

    Re: How to dismantle a Magimix 5100

    Ok thanks, i’ll try that, so basically the old shaft is cut through about 10mm from top & it then comes up, slips off?? & new one just pushes on from the top? I’lll try that on Monday thanks

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.