- This topic has 3 replies, 3 voices, and was last updated 20 years, 6 months ago by
.
-
Posts
-
Ikea built in model. Washes dishes fine. Leaves dirty water in bottom of machine once finished.
If I put machine on rinse, rinse cycle ok, drains, machine at bottom empty. Water then slowly fills machine to cover maybe 20mm at base!! This looks like drainage water – ie. not from cold inlet. Could this be re-entering machine from drainage hose? Syphoning from somewhere?
Re: Whirlpool DWF416 draining problem
mckean wrote: Could this be re-entering machine from drainage hose? Syphoning from somewhere?
It sounds very much like it. I’m guessing that the drain hose is connected to a spiggot on the sink trap ?
If it is, make sure that at some point the hose loops higher than the lowest part of the sink, that should stop it 🙂
Dave.
Re: Whirlpool DWF416 draining problem
for troubles with draining
make sure u connect draining to standpipe
NEVER to sink
free draining
no upstruction
u bend
3/4 of hight of machine
use 180 {e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} u bend
dropp of water helps to drain
Never CONNECT TO DRAINING OF SINK
or with washer
make sure FREE run
kitchen builders need training WOT NOT TO DO
follow manifacterers instructions
- You must be logged in to reply to this topic.