Whirlpool Dishwasher ADP 5966

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool Dishwasher ADP 5966

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • October 6, 2005 at 7:50 pm #12420
    signetone
    Participant

    Hi,

    First it was a flashing start button, then code F3 now code F5.

    Any ideas please.

    Thanks

    Brian

    October 6, 2005 at 8:05 pm #149554
    litlor
    Participant

    Re: Whirlpool Dishwasher ADP 5966

    Check if its heating the water also check top spray arm for blockage covers both F3 and F5 codes


    John

    October 6, 2005 at 8:13 pm #149555
    signetone
    Participant

    Re: Whirlpool Dishwasher ADP 5966

    Hi

    Thanks for quick reply.

    It now takes ages [15 minutes] to rinse when put on wash. Then after pumping immediately gives code F7 and the start button flashes. This is when the machine is empty of water.

    Will check the top arm, am also checking the electrical connections onto the circuit board.

    Regards

    Brian

    October 6, 2005 at 8:17 pm #149556
    litlor
    Participant

    Re: Whirlpool Dishwasher ADP 5966

    Brian

    F7 points to water inlet pipe check there to


    John

    October 6, 2005 at 8:59 pm #149557
    signetone
    Participant

    Re: Whirlpool Dishwasher ADP 5966

    John,

    thanks for the information. Followed another lead and took out the control board and disconnected all the plugs and plugged them back in. It then took 30 minutes to rinse but has started to wash, taken the washing tablet and is heating up.

    This really does seem to be a badly made product [Hungary]

    Thanks for your help.

    The water inlet seems fine and the top arm has been checked.

    It’s just washing the long program now.

    Kind Regards

    Brian

    ps The 30 minute pre-rinse does seem to be long. It used to be just a few minutes?

    October 6, 2005 at 9:44 pm #149558
    signetone
    Participant

    Re: Whirlpool Dishwasher ADP 5966

    John,

    The machine has just stopped with the flashing start button, 6 flashes and a space, all other lights are ok.

    Any ideas?

    Thanks

    Brian

    October 6, 2005 at 11:18 pm #149559
    signetone
    Participant

    Re: Whirlpool Dishwasher ADP 5966

    Hi

    The machine continued to the end but the fan did not work.

    I assume the logic board has failed?

    thanks

    Brian

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.