Indesit Dish Washer, D63

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Indesit Dish Washer, D63

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 11, 2005 at 12:55 pm #12509
    JohnB
    Participant

    The above appliance caused the RCD to trip on my consumer unit. On inspection of the socket into which the dishwasher plug fits there is a brown scorch mark on the live ‘pin hole’. Other appliances worked ok in that socket when tested.

    However, when I tried plugging the D63 into another socket the result was the same: the RCD tripped. Could the fault lie in the fitted, sealed plug? Or is the fault more serious?

    I’m grateful for any advice that you might have!

    Thanks!
    😥

    October 11, 2005 at 2:35 pm #149983
    Dave_Conway
    Participant

    Re: Indesit Dish Washer, D63

    It’s more likely to lie within the appliance to be honest.

    Please don’t keep trying it, it may do more damage to other components. Best bet is ask an engineer to attend and rectify the fault for you 🙂

    Try Repairs@ for one. If you do decide to have a look, keep it unplugged at all times please :zap:

    Dave.

    October 11, 2005 at 2:50 pm #149984
    JohnB
    Participant

    Re: Indesit Dish Washer, D63

    Thanks, Dave. I feared as much!

    I’ve tried “Repairs” but there is no engineer in this area. I’ll have to try “Yellow Pages”

    Thanks again,

    John (Berry)

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.