Indesit W1L143S

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit W1L143S

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 13, 2005 at 6:20 pm #12560
    shandy
    Participant

    Any ideas on how to get the bearing housing away from the shaft, it one of those with 4 legs attatched to the outer metal tub with 8 bolts, all bolts and pulley removed but it wont budge.
    Wouldnt normally bother with this but attractive lady flutters her eye lids and eh ho im doing the job.
    Any info much appreciated.

    Regards
    John

    October 13, 2005 at 6:34 pm #150288
    Flyman
    Participant

    Re: Indesit W1L143S

    13mm bolt screwed right into the shaft then a couple of hits with a big hammer. Usually better to get it started before you remove the leg bolts to stop the housing damaging the tub which is paper thin. 😕

    October 13, 2005 at 6:42 pm #150289
    shandy
    Participant

    Re: Indesit W1L143S

    Tried hat but prob didnt hit it hard enough, will put leg bolts back in and thrape it, thers seems to be some kind of wedge on one of the kegs didnt know if this had anything to do with it, that wouldnt come out either.

    October 13, 2005 at 11:11 pm #150290
    leavemetogetonwithit
    Participant

    Re: Indesit W1L143S

    You realise that if the bearings are really done for and there’s any damage to the brass ring of the spider, it’s a BER ❗
    (Just had to try out my new found vocabulary 😉 ).
    Mike

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.