- This topic has 8 replies, 4 voices, and was last updated 20 years, 5 months ago by
.
-
Posts
-
hi
does anyone know bout these twin tubs custmor says spinner makin a rubber smell? and now not spinning
any ideas
regards
tonyRe: norfost twin tub
thats what i thought but custmor wont be to happy if i tell them that lol so looks like have to get a new motor for it
Re: norfost twin tub
Good luck then 😆
There’s a thread somewhere about this thing and seperating the can from the motor.
Is it U/G still then and who passed the job to you ?
If it’s who I think it is and the rate is still the same I know what I’d tell them to do with it and it cannot be read before the 9pm watershead 🙂
Dave.
Re: norfost twin tub
got job sent from jtm it was purchased june 04 as u say pile of cr#p
got look at haier built under fridge rla 600 at same house can it get any worse fault freezin up at back even on low setting think stat any idea which universal to use
regards
tonyRe: norfost twin tub
Ah, so the work did move from ISDAL then 🙂
A better rate I hope 😉
And they have a Haier fridge as well :rotl: A wondeful collection of appliances then. If it’s a larder a VT9 with ice box VC1, assuming it has “normal” fittings.
Dave.
Re: norfost twin tub
Funny how all the dreadful makes end up in the same places isn’t it 😉
I have done one of these it was a cash job and unbelievably he wanted it done.
The trick is seperating the can from the shaft my old man knows a trick from yesteryear basically put the can under load and pour boiling water in and hey presto it pops out i will ask him tommorow for the finer details
by the way Tony are JTM still paying aborted call rate ?
LawrenceRe: norfost twin tub
no if it cancelled get no payment 🙁 which they did cos some times been to job found noone in out card them then get back to shop to find a fax to say job cancelled
Re: norfost twin tub
Lawrence wrote:
The trick is seperating the can from the shaft my old man knows a trick from yesteryear basically put the can under load and pour boiling water in and hey presto it pops out i will ask him tommorow for the finer detailsThat sounds like the old Hotpoint 1420 twin tub, I had a special tool made, a heavy chisel welded to a 2 foot iron rod, pour in the boiling water, wedge any spanner of the correct size under the lips of the spin can and place the rod down onto the motor shaft, lift the machine up with the spanner and clout the special rod with lump hammer.
- You must be logged in to reply to this topic.