Whirlpool AWM6140/3 can’t select Prog?

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool AWM6140/3 can’t select Prog?

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 27, 2005 at 1:31 pm #12870
    Martin
    Participant

    Turning the dial from off to any programme and the Timer/Module Unit just skips around and around. 😯

    The Start/Pause button lights up, the door interlock locks. Unable to stop or pause or command any control unless you rotate the dial to off 😕

    Is the Timer/Module Unit the fault I wonder? (I would guess it isn’t a common case that’s for sure as most wholesalers have no stock holding of this part- costly too!)

    Please can you advise? 😀

    October 27, 2005 at 3:13 pm #152004
    Dave_Conway
    Participant

    Re: Whirlpool AWM6140/3 can’t select Prog?

    I’ve had a couple of these do exactly that so I think it probably is, as long as everything else checks out OK, there’s little else it can be 😀

    JM11 should be able to help with the part, PM 😉

    Dave.

    October 28, 2005 at 5:36 am #152005
    SparkyP
    Participant

    Re: Whirlpool AWM6140/3 can’t select Prog?

    Hi Martin
    It is definately the timer and even the SAM won’t cure it. It is not a software fault but a hardware one.
    If you have problems getting a timer give me a pm as i have some in stock. The 12 nc of the machine is 857061415330 i do believe because there is only one 6140/3. I will even program it with the SAM for you.

    Sparkyp

    October 28, 2005 at 7:21 am #152006
    Martin
    Participant

    Re: Whirlpool AWM6140/3 can’t select Prog?

    SparkyP wrote:If you have problems getting a timer give me a pm as i have some in stock.

    What a splendid chap you are 🙂

    Yes please! Please PM the details to me Sparky thanks :tup:

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.