Hoover HCA 390FFK

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HCA 390FFK

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 27, 2005 at 8:04 pm #12875
    AMS
    Participant

    Hi all,

    I’ve got to go to one of these fridge/freezers tomorrow and was wondering if any of you boffins could point me in the right direction. The fault is a too cold fridge compartment – things are freezing up and there is always ice on the inside back wall of the fridge, even with stat turned down to 1. Freezer appears ok. I’ve trawled the forums and have discovered that this is an electronically controlled machine and possible faults could be fridge temp sensor or pcb. How can I isolate the fault? Where are the bits located? Easy to change? Part nos? Prices? etc..

    Thanking you all in anticipation,

    Dave

    P.S. I wouldn’t normally do refrigeration, but this is for a neighbour and my reputation may depend on it!

    October 27, 2005 at 8:38 pm #152051
    Simon46
    Participant

    Re: Hoover HCA 390FFK

    BobHope is an expert on these. If the module fails it will run continuously So the freezer food is not lost. Have a look at it. I have had modules of QER for this problem.

    Regards
    Simon.

    October 28, 2005 at 2:25 pm #152052
    Mark1
    Participant

    I’ve had this problem on a few HCA models. Nearly always the P.C.B. Quite often the screws are hidden behind the stick on facia. hope this helps and is not too late for you Mark

    October 30, 2005 at 3:16 pm #152053
    AMS
    Participant

    Re: Hoover HCA 390FFK

    Thanks for the replies guys.

    Dave

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.