AEG fault codes

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › AEG fault codes

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 21, 2005 at 6:06 pm #13467
    boywonder
    Participant

    HI,
    Wonder if anyone can help, I went to repair an AEG which was about 6years old, the one with the stainless outer drum not the latter version with the zanussi type tub. It was showing fault C09, I reset the board, replaced the brushes, tested the machine and left. The customer phoned back to say the machine was completing the cycle but was showing fault
    C08, but the fault was not locking the board as usual and she could do another wash. Returned to machine and fault does not occur on a spin or rinse and spin program. Checked the heater and anything that could cause a timeout fault. Any info gratefully recieved 😯 ❓

    November 21, 2005 at 6:53 pm #155055
    pen0668
    Participant

    Re: AEG fault codes

    have you checked ntc for problems??
    also do you have model no / pnc nos
    if so i will look up info for you

    November 21, 2005 at 9:46 pm #155056
    TELL
    Participant

    Re: AEG fault codes

    c8 in my books come up the same, ntc – either s/c or o/c, and ntc wiring o/c..
    TELL..

    November 22, 2005 at 4:45 pm #155057
    boywonder
    Participant

    Re: AEG fault codes

    Thanks will check and get back to you 😉

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.