- This topic has 4 replies, 3 voices, and was last updated 20 years, 4 months ago by
.
-
Posts
-
Hi everybody.
This dishwasher leaks from the point where the water softner chamber joins the water softner itself.
There are three rubber seals which seem ok,but the water forces it way thru.
It seems too much water stays in the softner pot and and causes a preesure which forces the water out.
Could this be because the solonoid valve attached to the pot is`nt working or someother fault.
All suggestions gratefully received.
Thanks.
Chris.
Re: Hoover D821
Come across this old thread in my search for an answer. Having same problem. Water is forcing itself out from the ‘o’ ring connection between upper and lower softener units. Have replaced upper softener panel (91670172) in case of a fine crack or faulty seam. ‘O’ rings seam fine. No blockage in salt/resin container. Did find a small piece of plastic caught inside the grey nozzle insert (92694801) at base of sump. However fault still there. Help much appreciated!
RickRe: Hoover D821
had this fault a few weeks ago replaced the o rings even though they seemed ok problem solved hope this helps
Re: Hoover D821
Sorry Rick but I can`t remember.
Its a long time ago and I have trouble remembering what I did yesterday.
Put it up in Technical on Forums,somebody may have the answer.
Chris.
- You must be logged in to reply to this topic.