Baumatic DW – BDW13

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Baumatic DW – BDW13

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 7, 2005 at 9:48 pm #13912
    RocketMan
    Participant

    Been out to this integrated DW. Customer says it comes up with E3 error code (although his wife says it was E4). Also it’s not getting up to temperature quick enough (sounds like it’s timing out). Customer says it only gets up to about 21 degrees (one of the displays gives you the temperature) but then comes up with the error codes and stops. Anyone got Baumatic Error codes would be appreciated. 😯


    Thanks Steve

    December 7, 2005 at 10:09 pm #157149
    eastlmark
    Moderator

    Re: Baumatic DW – BDW13

    Some Baumatics are SMeg made. would tye in witha smeg no heat fault code too. heater or cut out.

    December 7, 2005 at 10:25 pm #157150
    RocketMan
    Participant

    Re: Baumatic DW – BDW13

    eastlmark


    Thanks for that – the Smeg codes do look good I’ll check thermister

    Steve 😕

    December 8, 2005 at 11:36 am #157151
    EFS
    Participant

    Re: Baumatic DW – BDW13

    The only code I know for this model is E4 which is water in the base.
    I put a tube in and syphoned it out 💡 as its a b****r to get into.

    Steve

    December 9, 2005 at 8:44 pm #157152
    RocketMan
    Participant

    Re: Baumatic DW – BDW13

    I’m sure it’s E3 as there was not water in the base. It just times out on the heating but does heat very slowly. I’ll let you know when I go back.

    Steve

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.