servis m3814 x16

This topic has 1 reply, 2 voices, and was last updated 20 years, 4 months ago by eng14.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
December 7, 2005 at 10:50 pm #13914

eng14
Participant

hi guys went to this m/c today ,cleared limescale got her filling again.worked for 2 loads then went through to spin and blew trip,she tied again same thing all up to spin.changed card on this one when i was with gb dar last year,any ideas ,richard ta 😮

December 8, 2005 at 7:21 am #157154

bobokines
Participant

Re: servis m3814 x16

Could be the heater has warped due to going through heat pause with little or no water. It might be striking drum in mid spin.

Have you meggared the heater?

Otherwise I would go for a motor fault.

Bob
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.