Fisher Paykel GW509 Beeps on start up

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher Paykel GW509 Beeps on start up

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 11, 2005 at 2:10 am #13981
    fused
    Participant

    Hi all,

    Thanks for the technical help you’ve posted on this site so far, I’m sure you’ve saved many $ for the mr fixits.

    Can you provide info on this fault also? The machine powers up ok, but when start button pressed, short wash and spin LED’s illuminate accompanied by a beeping sound.

    The diagnostic results obtained (by pressing and holding water temp + power on) for hold and slow lights is 0000 1001, read as seen on the machine left to right. Ie the same LED’s as short wash and spin.

    Any ideas?

    Many thanks,

    December 11, 2005 at 9:53 pm #157387
    Penguin45
    Participant

    Re: Fisher Paykel GW509 Beeps on start up

    Looks like phase 5 size error.

    Hold “Temp Up” in, then hit “Power”. To set the machine for 5kg load, push “Wash Temp Up”, then “Power”. The Cold Water LED should light. To set the machine for 6kg load, push “Water Level Up” and “Power”. The Low Water LED should light. For 7kg, push “Spin Speed up”, then “Power”. Hold Spin Speed LED should light.

    To test, run a programme………

    Regards,
    Penguin45.

    December 12, 2005 at 5:55 am #157388
    fused
    Participant

    Re: Fisher Paykel GW509 Beeps on start up

    Mate, beautiful….it’s filling up on a test run all seems to be ok at this early stage so thankyou very much. The ol’ phase 5 size error eh…?
    It’s progressing nicely now, cheers…! If you were local I’d buy you a beer…

    Regards,

    Glen

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.