Whirlpool Dishwasher ADG450-3

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool Dishwasher ADG450-3

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 12, 2005 at 10:07 pm #14014
    bassman
    Participant

    Can anyone help with problem I looked at this dishwasher today machine was permanently pumping looked in base base was full of water cleared water no sign of leak ran machine it fills for about 20 secs stops then tries again I watched water going into softener but water does not come back out of fill chamber into machine I have never had a water softener block up before but it is the only thing I can put it down to .
    Any suggestions welcome sensible ones only please!
    Bassman

    December 13, 2005 at 4:53 pm #157520
    Beta
    Participant

    Re: Whirlpool Dishwasher ADG450-3

    i have come across the water filter blocking-up, from what i believe a lot of the w`pools have an overflow from the filter. This could be the source of the leak.

    December 13, 2005 at 8:57 pm #157521
    bassman
    Participant

    Re: Whirlpool Dishwasher ADG450-3

    Thanks For The Info I am going back tomorrow to recheck as the softner assembly is very expensive.
    Thanks again Bassman

    December 13, 2005 at 10:26 pm #157522
    gegsy
    Participant

    Re: Whirlpool Dishwasher ADG450-3

    Hi
    Customers dont seem to undersatnd that 3 in 1 means just that and still insist on puttin salt and rinse aid in the relevant compartments.
    Overdosing like this esp the rinse aid causes excessive foam thus confusing level sensor and leading to the type of fault you have.

    Greg

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.