Smeg not completing cycle – No error codes.

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Smeg not completing cycle – No error codes.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • January 7, 2006 at 10:30 pm #14622
    Simannjo
    Participant

    Hi All,
    Hope someone can help with a Smeg Dishwasher that refuses to complete a wash cycle. Rinse and Empty work fine, but on a complete cycle it stops about 2 thirds through (Just before drying phase?) and remains full of hot water.
    The lights on the front door all light up steady.
    All plumbing has been removed and cleaned out with little gunge removed. (Thanks for the previous posts guys)
    2 pressure sensors have continuity and no continuity when operated. Float operated switch also has continuity.
    Sorry about the lack of component names!

    P.S. Can’t seem to find a model number – Any ideas?

    January 8, 2006 at 12:13 am #160179
    gegsy
    Participant

    Re: Smeg not completing cycle – No error codes.

    Hi
    The drain pump could possibly be jamming when the water is hot??
    Model number will be on r/h edge of stainless door inner (sticker) just to give us more to go on. 😉

    Greg

    January 8, 2006 at 9:27 am #160180
    Simannjo
    Participant

    Re: Smeg not completing cycle – No error codes.

    Thanks for that Greg,

    Its a Type 11043 and the Model is DWD63SSE.
    I am assuming the drain pump is on the bottom right hand side front when facing the front of the dishwasher, attached directly to the sump, clipped in and held on with one screw!
    To test this would I have to watch for a supply voltage throughout a cycle and see the voltage continue when the pump stops?

    Hope this helps

    January 8, 2006 at 10:20 am #160181
    gegsy
    Participant

    Re: Smeg not completing cycle – No error codes.

    Live testing of any components cannot be advised on this site for obvious reasons, even though it may be the most practical.

    Greg

    January 8, 2006 at 11:05 am #160182
    Simannjo
    Participant

    Re: Smeg not completing cycle – No error codes.

    Many thanks anyway… 😉

    January 9, 2006 at 8:11 am #160183
    Simannjo
    Participant

    Re: Smeg not completing cycle – No error codes.

    Stripped door down to access control panel to check boards for wetness, dry joints etc and found nothing.
    Rebuilt and now all is OK – For the time being!!! 🙄

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.