- This topic has 5 replies, 2 voices, and was last updated 20 years, 2 months ago by
.
-
Posts
-
😥
I have a fully integrated Firenzi DW930 dishwasher which was running at the time we had a power cut. It now doesn’t seem to get past the rinse stage and the water doesn’t seem to get hot. It also beeps constantly when it thinks it has finished( at which point I have to open the door)!! I have tried actually unplugging from the mains – but no change. Thank you Jane
Re: Helppp… Firenzi DW930 & Power Cut
This is a Whirlpool made dishwasher, accompanying the bleeps will be a flashing light sequence (x flashes – pause – x flashes etc).
If you can check that it may help 🙂
Dave.
Re: Helppp… Firenzi DW930 & Power Cut
Dave_Conway wrote:This is a Whirlpool made dishwasher, accompanying the bleeps will be a flashing light sequence (x flashes – pause – x flashes etc).
If you can check that it may help 🙂
Dave.
It beeps constantly until I open the door. The only light on on the inside of the dishwasher is the rinse mode and the power light. I don’t think any of the lights are flashing…
Re: Helppp… Firenzi DW930 & Power Cut
The power light will be flashing when the error occcurs normally, if it isn’t then it’s engineer time to be honest on one of these electronically controlled appliances.
Check the repairs@ link below 🙂
Dave.
Re: Helppp… Firenzi DW930 & Power Cut
The power light will be flashing when the error occcurs normally, if it isn’t then it’s engineer time to be honest on one of these electronically controlled appliances.
Check the repairs@ link below 🙂
Hi Dave,
Me again. I ran the dishwasher last night and after 30-40 minutes (when it sounds like it is washing) it did its usual continuous beeping until I opened the door…. – the Rinse light was on and the Start light was flashing. Again not a complete wash and no hot water so stuck on the rinse cycle.
Jane
- You must be logged in to reply to this topic.