w/pool d/washer ADG993 (854299315120)

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › w/pool d/washer ADG993 (854299315120)

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 3, 2006 at 7:42 pm #15365
    TELL
    Participant

    went to this m/c found water in base. no flood switch, or any display codes off the board. dead no functions. selector switching the green indicators for the wash progs, no start light, no pulse to start, power to facia selector, out down to main pcb, in bottom. no broken wires found, checked thermistor ok, heater ok, also checked level switch on side of sump,activating ok through switches. still wont start, any idea’s lads. me thinks the main pcb, or is there some else to look for. priced pcb from connect, expensive wrong diagnoses.
    ta TELL..

    February 3, 2006 at 8:50 pm #163299
    Penguin45
    Participant

    Re: w/pool d/washer ADG993 (854299315120)

    TELL wrote:expensive wrong diagnoses.

    Re-con boards available from the usual sources at much more sensible prices……….

    Chris.

    February 3, 2006 at 11:50 pm #163300
    gegsy
    Participant

    Re: w/pool d/washer ADG993 (854299315120)

    Hi
    It does sound like main PCB. When you get new PCB before you install for godsake check all components for short circuit. If any components are they will immediatly pop your new board as soon as you select a programme 👿

    Greg

    February 4, 2006 at 10:56 am #163301
    gegsy
    Participant

    Re: w/pool d/washer ADG993 (854299315120)

    ….. and earth leakage 😉

    Greg

    February 4, 2006 at 12:05 pm #163302
    TELL
    Participant

    Re: w/pool d/washer ADG993 (854299315120)

    thanks gegsy, and penguin. 1/2 thought that was the fault. but could not see anything on the board, wanted to make sure. all components checkout ok, any idea why its gone??.
    ta TELL..

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.