- This topic has 4 replies, 3 voices, and was last updated 20 years, 1 month ago by
.
-
Posts
-
Hi,
Have an AEG F86070VI (911235210/00) integrated dishwasher to repair. The customer says it has always been faulty since he bought the house, AEG never cured the fault. If using the 50 ECO prog, halfway through it beeps an error, he resets and it completes. He thinks it shows 10 in the display at this point, and flashes the fill light (looks like a tap?). If you select a higher temp wash the programme errors more than once. I had a very quick look at it today; it heated from cold on the intense 70 prog but only to around 30-40 degrees, had to go; Chelsea kicking off…………… 😯Any advice would be appreciated.
I do not know this DW that well and cannot find error codes in the list above.Cheers
GraemeRe: AEG F86070VI dishwasher 10 error
You’ll be in for some stick when “Boro” sees this post…..
Ickle file on the way.
Chris.
Re: AEG F86070VI dishwasher 10 error
Thanks for the file Chris 😀
The rubber air trap may need tying-up to stop water sitting in the bottom, if anyone else has the same problem.
Graeme
Re: AEG F86070VI dishwasher 10 error
had to go; Chelsea kicking off…………… Shocked
Any advice would be appreciated.
Yeah drop Carvalho, and Geremi is no right back 😆
As for the d/w aint got a clue mate.
Re: AEG F86070VI dishwasher 10 error
boro wrote:
Yeah drop Carvalho, and Geremi is no right back 😆
As for the d/w aint got a clue mate.
Very true 🙂 Why do your lot only turn up every 4 weeks?
Back to the dishwasher, checked and raised the air-trap today; still have the save fault. It errors after about 1/2 hour, small amount of water in the sump so probably filling or draining. Every time I try a fill or drain it works fine. May have to give up on this unless any further suggestions? (Not from Boro!)
Cheers
Graeme
- You must be logged in to reply to this topic.