Prima LPR 600 Dishwasher fault

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Prima LPR 600 Dishwasher fault

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 15, 2006 at 8:54 am #15651
    scania19
    Participant

    Our dishwasher leaves the dishes cold, wet and clean at the end of the cycle.
    This is a machine made by whirlpool, serial number is 854560015810, found on the door.
    Has anyone any idea what could be wrong?
    There are no lighhts that blink/flash or noises.

    Thanks scania19

    February 15, 2006 at 9:50 am #164368
    gegsy
    Participant

    Re: Prima LPR 600 Dishwasher fault

    Hi
    How long after cycle do you leave the dishes in the appliance? If its longer than a few hours condensation may form and give you the problem you have.
    The appliance uses the same heater for washing and drying. If there was a fault it would notify you.

    Greg

    February 15, 2006 at 1:52 pm #164369
    scania19
    Participant

    Re: Prima LPR 600 Dishwasher fault

    Thanks Gregsy,
    this has just started to happen, we have always set it to run through the night and never had any condesation problems.

    You mentioned it would tell us. How?

    scania19

    February 17, 2006 at 6:40 am #164370
    DentedPorsche
    Participant

    Re: Prima LPR 600 Dishwasher fault

    The start light should be flashing to indicate a fault. The number of flashes between the short pause indicate the error code.
    If it’s not flashing then it’s possible the electronic module is faulty although there are numerous other possible causes.
    To be honest, with this type of fault you’re going to need an engineer to diagnose properly, rather than throwing parts at it.
    Click on repairs@ on the left side of the page to find a repairer in your area, or post your post code here.

    DP

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.