Not sure if this is an error code Zanussi

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Not sure if this is an error code Zanussi

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 20, 2006 at 5:26 pm #15775
    robbra
    Participant

    Zan FS1255W…914791102/00
    select fill…ok. Select drain, door locks, end LED flashes 4 times with 2 flashes, then door lock clunks and lights go out. nothing else.
    Customer lost bra wire, machine wouldn’t empty. Nothing in pump, metered ok, element ok. Any clues where to look.
    Thanks Rob

    February 22, 2006 at 3:52 pm #166277
    robbra
    Participant

    Re: Not sure if this is an error code Zanussi

    well no answers but live in hope.can anyone supply part no for main pcb. Thanks
    Rob

    February 22, 2006 at 4:29 pm #166278
    Martin
    Participant

    Re: Not sure if this is an error code Zanussi

    robbra wrote:well no answers but live in hope.can anyone supply part no for main pcb.

    973914791102002 pre-configured (About £130??)

    February 22, 2006 at 4:50 pm #166279
    robbra
    Participant

    Re: Not sure if this is an error code Zanussi

    Thanks Martin. looks like another for the scrapyard
    Rob

    February 22, 2006 at 11:31 pm #166280
    aqualectric
    Participant

    Re: Not sure if this is an error code Zanussi

    I have had similar probs with these machines (uses the delta pcb, methinks). When the user interface (facia) goes dead, it’s always worth trying to clean and tighten the little strip connector on the bottom of the facia pcb.
    Remove the facia and gently wiggle the connector off. (there is also a little plastic barb holding the plug in place – these break easily). You can remove the pcb from its location and clean the contact strips and pinch the plug lightly together with pliers so it goes back on tightly. Then refit pcb to facia and fit back on machine.
    I have had a good rate of success with this – about 10 mins work all told.
    Worth a try!!! 😉

    February 23, 2006 at 8:04 am #166281
    robbra
    Participant

    Re: Not sure if this is an error code Zanussi

    Thanks for that, and you are just down the road if I need help. Will let you know how it goes.
    Rob

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.