hotpoint wma44

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wma44

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 22, 2006 at 9:35 pm #15831
    hilly
    Participant

    arrived at this machine today and found obstruction in drain pump i replaced pump but the machine wont reset it just keeps filling and draining at the same time i am thinking its a fault on the module?
    would i be right ? theres no visual damage.


    thanks paul

    February 22, 2006 at 10:28 pm #166526
    iadom
    Moderator

    Re: hotpoint wma44

    Paul, you could run the ‘last error detected’ routine shown in the ‘Error codes’ thread at the top of this forum. Also check your e-mail. 😉

    Jim.

    February 25, 2006 at 9:57 pm #166527
    hilly
    Participant

    Re: hotpoint wma44

    thanks for email very useful although it didnt solve the problem this time
    thanks for the help

    paul

    February 25, 2006 at 10:06 pm #166528
    iadom
    Moderator

    Re: hotpoint wma44

    Please let us know of the final outcome on this, it all helps towards the knowledge base. 😉

    I would be looking at the pressure switch before the module though.

    February 27, 2006 at 10:37 pm #166529
    HotDog
    Participant

    Re: hotpoint wma44

    I would go for p/switch could be over filling causing pump to operate to preventing flooding also check harness near front balance weight possible chaffing common fault if no luck change board

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.