Fisher & Paykel 058 No Spin

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher & Paykel 058 No Spin

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 4, 2006 at 4:31 am #16089
    nessie
    Participant

    I have a F & P MW058U washer that progresses through all stages until the spin phase where it stops and beeps with LEDs in the pattern (left to right) 00001011.

    This is the same bit pattern shown in the diagnostics mode.(Temp Dn, Spin Up till Hold + Slow).

    Any assistance would be very much appreciated.

    March 4, 2006 at 9:01 pm #167500
    Penguin45
    Participant

    Re: Fisher & Paykel 058 No Spin

    Pressure switch not responding correctly – it thinks that the machine is full when it’s not.

    Ensure that the tub is fully empty, remove air hose from switch and blow through to clear any water. Ensure that it’s not kinked or trapped, reconnect and try again.

    Power off when going inside.

    Regards,
    Penguin45.

    March 6, 2006 at 8:18 am #167501
    nessie
    Participant

    Re: Fisher & Paykel 058 No Spin

    Spot on Penguin45 – Water in the air hose.
    Blown clear all functions fine.
    I owe you one. :beer:

    Thanks
    Nessie. 😀

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.