Servis M3008W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Servis M3008W

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • March 18, 2006 at 1:29 pm #16468
    Bryan
    Participant

    Not been to look at this machine yet but customer tells me it`ll go right through its wash/rinse cycle but when it comes to spin it will not get up to speed and she`s tried various different loads.
    Anyone got the definitive answer on this fault because with Servis it seems to be a case of , might be the belt , might be the module and might even be the motor 🙄 :cry:.
    I did ask customer to check “no spin” switch.

    As usual with Servis owners they don`t want to spend much on it and any help would be much appreciated.

    Bryan

    March 18, 2006 at 3:01 pm #169933
    Bill
    Participant

    Re: Servis M3008W

    Bryan,

    If it is not going into final spin it could be the P.C.B.

    Bill Ellis :scot:

    March 18, 2006 at 5:01 pm #169934
    Penguin45
    Participant

    Re: Servis M3008W

    Or the elasticated drive belt – belt tension should seem to be excessive.

    Chris.

    March 18, 2006 at 6:04 pm #169935
    gegsy
    Participant

    Re: Servis M3008W

    Check pressure system is clear and pressure switch contacts working aswell.

    Greg

    March 18, 2006 at 6:56 pm #169936
    Penguin45
    Participant

    Re: Servis M3008W

    My post is incorrect – this machine has an induction motor……. 😳

    Module most likely culprit after all.

    Chris.

    March 20, 2006 at 12:11 am #169937
    whitevanman
    Participant

    Re: Servis M3008W

    simple test when worked for N’Homecare -SUK in guarantee ,could try dropping motor to create big tension (pulley/belt/motor) if works okay, if not as advised previously replace pcb may have one spare if required pm me.

    Wayne

    March 20, 2006 at 7:38 am #169938
    Simon46
    Participant

    Re: Servis M3008W

    If it smells check the pressure vessel for sludge first.

    Regards
    Simon

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.