Beko WMB10

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Beko WMB10

  • This topic has 3 replies, 2 voices, and was last updated 20 years ago by cis.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 2, 2006 at 10:00 pm #16862
    cis
    Participant

    The bearings have gone in my Washing Machine,

    How do I remove the bearings on this machine ?, Ive taken the back off, but cant see how to get them out as they seem to be recessed.

    Is it a case of removing them from the drum side ?

    A quick guide would be great

    Thanks

    April 2, 2006 at 11:50 pm #171919
    Penguin45
    Participant

    Re: Beko WMB10

    The bearings and seals are contained in a tube through the centre of the drum. You need rear access to remove the pulley and the front of the machine will come off as well, allowing you to get at the front of the tub.

    Power off, of course.

    Regards,
    Penguin45.

    April 3, 2006 at 6:53 am #171920
    cis
    Participant

    Ive got access to rear, so that bits okay

    “the front of the machine will come off as well, allowing you to get at the front of the tub.”

    How do I remove the front for access ?, will rmoving teh clips around teh front part of the outer drum allow me to remove the inner drum and get access to the bearings ?

    Thanks

    April 3, 2006 at 11:54 pm #171921
    Penguin45
    Participant

    Re: Beko WMB10

    Look cis, we aren’t allowed to walk you through it blow by blow – please check this:

    http://www.ukwhitegoods.co.uk/modules.p … pic&t=4359

    However – remove the kick board, you will find 3 screws. Consider that the door seal is attached to the front panel, so it will have to be released, as will the door lock.

    Really, if you’re not sure, please get pro help.

    Regards,
    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.