F & P Smartdrive 708

Re: F & P Smartdrive 708

Share your codes with us, we can help.

You can’t have a manual unless you mug an F+P engineer.

Regards,
Penguin45.

Re: F & P Smartdrive 708

Sorry – your post said “showing error codes”.

With the power off, press “Wash Temp Down” and then press “Power”. After the two “beeps”, press “Spin” buttons until “Hold” and “Slow SPin” lights are lit. The wash programme board lights will now show a pattern of lights. These represent a binary code – if you will read them from left to right where “on” = 1 and “off” = 0 we can figure it out.

Regards,
Penguin45.

Re: F & P Smartdrive 708

There’s only 8 lights on the display board…. Sorry, but that code doesn’t work. Have another go, please.

Alternatively, tell us what the machine is actually up to and maybe we can figure it out that way.

Regards,
Penguin45.

Re: F & P Smartdrive 708

OK, we can do something with that one….

Rotor position sensor fault. This can be caused by (normally) dodgy/corroded wiring. The sensors themselves can be faulty, worst case is the motor controlloer board, although this is unusual.

HTH,
Penguin45.

Re: F & P Smartdrive 708

It sounds like the rotor is loose on the shaft and is hitting something. Access is by removing the large centre nut and easing the rotor away – store in a large poly bag immediately as every bit of metal within 50 yards will try and stick to it.

The sensor should not be loose BTW.

You’ll have to carry out a thorough inspection for the damaged plastic pieces to see where they may have come from.

Can’t tell you much more really,
HTH,
Penguin45.

Re: F & P Smartdrive 708

5/8″ socket should shift it.

Penguin45.

Re: F & P Smartdrive 708

Vibration presumably.

Decision time now – replacement stator and sensor are going to be expensive (can’t help you there, being in England). P/nos are:

426181P – Stator kit
425221P – Rotor position sensor

Good luck with it,
Penguin45.