Diplomat ADP8252

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP8252

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 6, 2006 at 8:46 pm #16970
    noswad
    Participant

    Can Anyone tell me what’s wrong with my dishwasher. After you turn it on, the display says P0 and beeps twice. I can’t flick between programs and this has happened before but it seemed to repair itself. However, it has now ben like this for two weeks. Do I need to call an engineer out ?

    Jimmy

    April 6, 2006 at 9:42 pm #172344
    Dave_Conway
    Participant

    Re: Diplomat ADP8252

    noswad wrote:Do I need to call an engineer out ?

    I think it may be best in this case as PO isn’t a fault code or any known display. It’s probably another component failure in the dishwasher throwing the software on the PCB in to confusion, now unkown on these models.

    Check the repairs@ link below 🙂

    Dave.

    April 6, 2006 at 10:16 pm #172345
    noswad
    Participant

    Re: Diplomat ADP8252

    P0 isn’t a fault, it’s program 0 which usually shows after it has finished a cycle

    jimmy

    April 6, 2006 at 10:24 pm #172346
    Dave_Conway
    Participant

    Re: Diplomat ADP8252

    Ah, sorry, I thought this was happening after a programme had been selected.

    Same advice applies though 🙂

    Dave.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.